C-Bus/BACnet Gateway CB-100
Installation
The C-Bus to BACnet gateway supports DIN-rail mounting. Select the mounting position with adequate space and heat dissipation and connect the interfaces. The 10/100Base-T(X) Ethernet port is equipped with RJ45 connector. For the C-Bus connectivity, there is an RS-485 terminal available. A 24V DC power source must power the gateway.
If the default C-Bus address 29 is not free, to avoid C-Bus collisions, connect the C-Bus later after you change the C-Bus address (see Configuration).
LEDs
| LED | Mode |
|---|---|
| Power | ON when the power is connected, and the gateway operates properly |
| Prog | ON when the system is in programming mode (e.g. installation of a new license key) |
| Tx | C-Bus link layer transmit |
| Rx | C-Bus link layer receive |
Technical Specification
| Max. number of C-Bus controllers | 29 |
| Max number of C-Bus data points | 2950 |
| Default C-Bus address | 29 |
| Default IP address | 192.168.1.222 |
| Ethernet connection | 10/100Base-T(X), RJ-45 | Power supply | 24 Vdc, 0.6 A |
| Temperature range | -10 .... +60 °C |
| Mounting dimensions (L x W x H) | 212 x 90 x 60 mm (83.5 x 3.5 x 2.4 inch) |
Designed and Made in EU